FAQ - Should I use wet application when installing my permanent vinyl digits?

For Economy Permanent Vinyl

It can be helpful to use the wet method to avoid bubbles. The wet method consists of .5 oz of denatured alcohol and 1/16 teaspoon of Dawn dish soap to an 8 oz. spray bottle of water. Spray a fine mist on the back of the vinyl and the surface of application. Don't puddle. Align the digits and start to squeegee the fluid out from behind the vinyl until there are no bubbles. Let sit for a few minutes and remove the application tape, making sure the vinyl does not lift with the tape.

See full instructions on how to install Economy Permanent Vinyl digits here.

For Premium Permanent Vinyl

These should be installed dry. This vinyl has air egress adhesive, meaning that the adhesive has tiny ridges in it that will allow you to lightly squeegee air bubbles out before heavier squeegeeing. Using the wet method can actually result in water getting trapped in the adhesive ridges and causing premature failure.

See full instructions on how to install Premium Permanent Vinyl digits here.