Install - How to Install Premium Permanent Autocross Digits

Note: If your decal was shipped rolled or folded, there may be wrinkles in the transfer layer. The sticker will not be wrinkled. To ease installation, let the decal sit on a flat surface and go over any wrinkles in the transfer paper with the included squeegee.

Needed tools: Painter’s tape, squeegee (included), tape measure/ruler

How to apply your decals:

Clean

Wipe clean the car or surface to which you are applying the decal with a mild cleaner. Allow to dry. Note that wax and ceramic coatings can have an adverse affect on adhesion.

Tape Onto Vehicle

Place a strip of tape along the top of the digit or panel and tape to the car. This is your chance to get everything aligned perfectly.

Peal the Backing Paper Off

Hinge the decal up and carefully peel off the backing layer. Only the vinyl and transfer layer should remain.

Align and Apply

Let your decal down to the car's surface. Starting at the top, use a credit card to rub and smooth the decal with the supplied squeegee, working down from the middle to the outsides.

Remove the Transfer Paper

Remove the transfer layer by peeling it off slowly, starting from the corner. Now only the vinyl decal will remain on the surface.

*Sometimes, air gets trapped under a part of the vinyl. In this case, use a tiny pin, needle or xacto knife to poke a small hole in the bubble and force the air out with your finger. Additionally, small bubbles will disappear over time.

Installation of premium digits and panels: